Question 60
During a scheduled deployment at a municipal IT division in Portland, a tagged user VLAN must be routed over a bundled uplink rather than each physical member individually. The team is verifying its effect on citizen portals. Which acceptance outcome addresses the precise requirement?
Explanation
Correct Answer
At a municipal IT division in Portland, this verifies the specific aggregate ethernet interfaces requirement rather than merely recording an intended configuration: The tagged VLAN is routed through the aggregate subinterface and member ports do not have conflicting routed IP settings. The associated implementation is: add a suitable aggregate Ethernet Layer 3 subinterface for the VLAN and bind its router and zone.
Incorrect Answers
The offered observation would confirm the separate intervention: Align the firewall and switch LACP settings and compatible member parameters. It measures: The affected port joins the intended aggregate and interface counters advance on that member. The current aggregate ethernet interfaces configuration is Add a suitable aggregate Ethernet Layer 3 subinterface for the VLAN and bind its router and zone, and must demonstrate: The tagged VLAN is routed through the aggregate subinterface and member ports do not have conflicting routed IP settings. The two acceptance checks are not interchangeable even though they share a feature area.
That observation measures virtual wire interfaces after this other intervention: Configure the virtual wire and its allowed VLAN-tag behavior for the traffic, with zone policy. Its result is: Tagged packets traverse only when the defined tag handling and security policy allow them. The requested aggregate ethernet interfaces change is Add a suitable aggregate Ethernet Layer 3 subinterface for the VLAN and bind its router and zone, which must demonstrate: The tagged VLAN is routed through the aggregate subinterface and member ports do not have conflicting routed IP settings. The offered evidence does not validate the specified control.
The offered observation would confirm the separate intervention: Create an aggregate Ethernet interface and assign supported members with matched switch-side bundling. It measures: The logical AE remains operational after one member link is disabled and forwarding uses the surviving member. The current aggregate ethernet interfaces configuration is Add a suitable aggregate Ethernet Layer 3 subinterface for the VLAN and bind its router and zone, and must demonstrate: The tagged VLAN is routed through the aggregate subinterface and member ports do not have conflicting routed IP settings. The two acceptance checks are not interchangeable even though they share a feature area.