McAfee-Secured Website

Exam Code: JN0-106

Exam Name: Junos, Associate (JNCIA-Junos)

Certification Provider: Juniper

Corresponding Certification: JNCIA-Junos

100% Juniper JN0-106 Guaranteed Success With Testking Training Materials

Get Real JN0-106 Exam Questions & Expert Verified Answers as Experienced on the Real Exam!

98 Questions & Answers with Testing Engine

"Junos, Associate (JNCIA-Junos) Exam", also known as JN0-106 exam, is a Juniper certification exam.

Pass your tests with the always up-to-date JN0-106 Exam Engine. Your JN0-106 training materials keep you at the head of the pack!

Satisfaction Guaranteed

Money Back Guarantee

Testking provides hassle-free money back guarantee with our products. That is because we have 100% trust in the abilities of our professional and experience product team, and our record is a proof of that.

99.6% PASS RATE
Was: $137.49
Now: $124.99

Juniper JN0-106 Practice Test 105

Question 1040

Within Routing Policy and Firewall Filters, a technician selects this approach: Create a filter term matching protocol icmp, with the supported ICMP type condition if needed. Which original requirement or fault would most directly justify it?

  1. A firewall filter has only a permit term for a management subnet and no explicit final term.
  2. A filter should inspect packets as they arrive at an IPv4 logical interface, before routing onward.
  3. An operations team wants to count incoming IPv4 ICMP echo traffic separately from TCP.
  4. One upstream peer marks selected routes with a known BGP community and routing policy must distinguish them.

Explanation

Correct Answer

C:

IP protocol and ICMP-type conditions can identify selected diagnostic packet classes. This meets the stated need for firewall icmp match.

Incorrect Answers

A:

The implicit final filter discard scenario has a different requirement: Junos firewall filter processing normally discards packets that reach the implicit end without an accepting match. It does not directly meet the firewall icmp match need in this question.

B:

The input versus output attachment scenario has a different requirement: The input direction applies filter logic to packets entering the associated interface. It does not directly meet the firewall icmp match need in this question.

D:

The bgp community match scenario has a different requirement: BGP communities provide route attributes that policies can examine or modify for routing decisions. It does not directly meet the firewall icmp match need in this question.

Question 1041

Operators need a running counter for traffic matching one specific firewall filter term. Which configuration or troubleshooting action most directly meets the need?

  1. Use a supported then preference value action for the intended matching term.
  2. Create a filter term matching protocol icmp, with the supported ICMP type condition if needed.
  3. Use a then count action with a suitable counter name and a final packet decision.
  4. Use an appropriate then next term action rather than an immediate accept or reject.

Explanation

Correct Answer

C:

The count action increments a counter for matched packets and can be combined with forwarding disposition. This meets the stated need for firewall filter count action.

Incorrect Answers

A:

The policy route preference action scenario has a different requirement: Policy actions can modify preference attributes used later by route-selection logic. It does not directly meet the firewall filter count action need in this question.

B:

The firewall icmp match scenario has a different requirement: IP protocol and ICMP-type conditions can identify selected diagnostic packet classes. It does not directly meet the firewall filter count action need in this question.

D:

The policy next term scenario has a different requirement: Next term continues evaluation to a subsequent term in the same policy statement. It does not directly meet the firewall filter count action need in this question.

Question 1042

Within Routing Policy and Firewall Filters, a Junos engineer proposes the following response: Use a then count action with a suitable counter name and a final packet decision. Which concept or operating procedure is best illustrated?

  1. Policy route preference action
  2. Firewall ICMP match
  3. Policy next term
  4. Firewall filter count action

Explanation

Correct Answer

D:

The count action increments a counter for matched packets and can be combined with forwarding disposition. This meets the stated need for firewall filter count action.

Incorrect Answers

A:

The policy route preference action scenario has a different requirement: Policy actions can modify preference attributes used later by route-selection logic. It does not directly meet the firewall filter count action need in this question.

B:

The firewall icmp match scenario has a different requirement: IP protocol and ICMP-type conditions can identify selected diagnostic packet classes. It does not directly meet the firewall filter count action need in this question.

C:

The policy next term scenario has a different requirement: Next term continues evaluation to a subsequent term in the same policy statement. It does not directly meet the firewall filter count action need in this question.

Question 1043

Operators need a running counter for traffic matching one specific firewall filter term. The proposed response is: Use a then count action with a suitable counter name and a final packet decision. Which explanation most accurately supports this response?

  1. Policy actions can modify preference attributes used later by route-selection logic.
  2. The count action increments a counter for matched packets and can be combined with forwarding disposition.
  3. IP protocol and ICMP-type conditions can identify selected diagnostic packet classes.
  4. Next term continues evaluation to a subsequent term in the same policy statement.

Explanation

Correct Answer

B:

The count action increments a counter for matched packets and can be combined with forwarding disposition. This meets the stated need for firewall filter count action.

Incorrect Answers

A:

The policy route preference action scenario has a different requirement: Policy actions can modify preference attributes used later by route-selection logic. It does not directly meet the firewall filter count action need in this question.

C:

The firewall icmp match scenario has a different requirement: IP protocol and ICMP-type conditions can identify selected diagnostic packet classes. It does not directly meet the firewall filter count action need in this question.

D:

The policy next term scenario has a different requirement: Next term continues evaluation to a subsequent term in the same policy statement. It does not directly meet the firewall filter count action need in this question.

Question 1044

Within Routing Policy and Firewall Filters, a technician selects this approach: Use a then count action with a suitable counter name and a final packet decision. Which original requirement or fault would most directly justify it?

  1. An import policy should alter the selection preference for a subset of received routes.
  2. An operations team wants to count incoming IPv4 ICMP echo traffic separately from TCP.
  3. A route matches one policy term but should continue to a later term for further checks.
  4. Operators need a running counter for traffic matching one specific firewall filter term.

Explanation

Correct Answer

D:

The count action increments a counter for matched packets and can be combined with forwarding disposition. This meets the stated need for firewall filter count action.

Incorrect Answers

A:

The policy route preference action scenario has a different requirement: Policy actions can modify preference attributes used later by route-selection logic. It does not directly meet the firewall filter count action need in this question.

B:

The firewall icmp match scenario has a different requirement: IP protocol and ICMP-type conditions can identify selected diagnostic packet classes. It does not directly meet the firewall filter count action need in this question.

C:

The policy next term scenario has a different requirement: Next term continues evaluation to a subsequent term in the same policy statement. It does not directly meet the firewall filter count action need in this question.

Question 1045

An analyst needs logging of packets matching a suspicious flow pattern on an interface. Which configuration or troubleshooting action most directly meets the need?

  1. Combine protocol tcp with destination-port 22 in the relevant filter term.
  2. Attach the firewall filter as an input filter to the intended family inet interface.
  3. Use route-filter 198.51.100.0/24 exact.
  4. Configure a then log action for the targeted firewall filter term with an appropriate packet decision.

Explanation

Correct Answer

D:

Firewall filter logging records evidence of matched packets while the term's disposition controls forwarding. This meets the stated need for firewall filter log action.

Incorrect Answers

A:

The firewall destination-port match scenario has a different requirement: A destination-port match identifies the transport service being requested by the packet. It does not directly meet the firewall filter log action need in this question.

B:

The input versus output attachment scenario has a different requirement: The input direction applies filter logic to packets entering the associated interface. It does not directly meet the firewall filter log action need in this question.

C:

The exact route-filter match scenario has a different requirement: The exact route-filter match requires the specified network and prefix length to be the same. It does not directly meet the firewall filter log action need in this question.

Question 1046

Within Routing Policy and Firewall Filters, a Junos engineer proposes the following response: Configure a then log action for the targeted firewall filter term with an appropriate packet decision. Which concept or operating procedure is best illustrated?

  1. Firewall destination-port match
  2. Input versus output attachment
  3. Firewall filter log action
  4. Exact route-filter match

Explanation

Correct Answer

C:

Firewall filter logging records evidence of matched packets while the term's disposition controls forwarding. This meets the stated need for firewall filter log action.

Incorrect Answers

A:

The firewall destination-port match scenario has a different requirement: A destination-port match identifies the transport service being requested by the packet. It does not directly meet the firewall filter log action need in this question.

B:

The input versus output attachment scenario has a different requirement: The input direction applies filter logic to packets entering the associated interface. It does not directly meet the firewall filter log action need in this question.

D:

The exact route-filter match scenario has a different requirement: The exact route-filter match requires the specified network and prefix length to be the same. It does not directly meet the firewall filter log action need in this question.

Question 1047

An analyst needs logging of packets matching a suspicious flow pattern on an interface. The proposed response is: Configure a then log action for the targeted firewall filter term with an appropriate packet decision. Which explanation most accurately supports this response?

  1. A destination-port match identifies the transport service being requested by the packet.
  2. The input direction applies filter logic to packets entering the associated interface.
  3. The exact route-filter match requires the specified network and prefix length to be the same.
  4. Firewall filter logging records evidence of matched packets while the term's disposition controls forwarding.

Explanation

Correct Answer

D:

Firewall filter logging records evidence of matched packets while the term's disposition controls forwarding. This meets the stated need for firewall filter log action.

Incorrect Answers

A:

The firewall destination-port match scenario has a different requirement: A destination-port match identifies the transport service being requested by the packet. It does not directly meet the firewall filter log action need in this question.

B:

The input versus output attachment scenario has a different requirement: The input direction applies filter logic to packets entering the associated interface. It does not directly meet the firewall filter log action need in this question.

C:

The exact route-filter match scenario has a different requirement: The exact route-filter match requires the specified network and prefix length to be the same. It does not directly meet the firewall filter log action need in this question.

Question 1048

Within Routing Policy and Firewall Filters, a technician selects this approach: Configure a then log action for the targeted firewall filter term with an appropriate packet decision. Which original requirement or fault would most directly justify it?

  1. An analyst needs logging of packets matching a suspicious flow pattern on an interface.
  2. An interface filter should identify TCP traffic intended for the SSH service on port 22.
  3. A filter should inspect packets as they arrive at an IPv4 logical interface, before routing onward.
  4. A policy should match 198.51.100.0/24 but not its /25 subnets or its /23 aggregate.

Explanation

Correct Answer

A:

Firewall filter logging records evidence of matched packets while the term's disposition controls forwarding. This meets the stated need for firewall filter log action.

Incorrect Answers

B:

The firewall destination-port match scenario has a different requirement: A destination-port match identifies the transport service being requested by the packet. It does not directly meet the firewall filter log action need in this question.

C:

The input versus output attachment scenario has a different requirement: The input direction applies filter logic to packets entering the associated interface. It does not directly meet the firewall filter log action need in this question.

D:

The exact route-filter match scenario has a different requirement: The exact route-filter match requires the specified network and prefix length to be the same. It does not directly meet the firewall filter log action need in this question.

Question 1049

A stateless ingress policy should silently drop a known unwanted traffic class. Which configuration or troubleshooting action most directly meets the need?

  1. Apply a carefully designed input firewall filter to the lo0 interface as supported.
  2. Use then discard in the matching firewall filter term.
  3. Use then next policy where the configured policy chain supports it.
  4. Attach the firewall filter as an input filter to the intended family inet interface.

Explanation

Correct Answer

B:

Discard drops matched packets without explicitly returning an unreachable response. This meets the stated need for firewall filter discard action.

Incorrect Answers

A:

The protect routing engine lo0 scenario has a different requirement: A loopback input filter can protect traffic destined for the Routing Engine while preserving required protocol exchanges. It does not directly meet the firewall filter discard action need in this question.

C:

The policy next policy scenario has a different requirement: Next policy transfers evaluation to the next policy statement rather than finishing with a decision. It does not directly meet the firewall filter discard action need in this question.

D:

The input versus output attachment scenario has a different requirement: The input direction applies filter logic to packets entering the associated interface. It does not directly meet the firewall filter discard action need in this question.

Question 1050

Within Routing Policy and Firewall Filters, a Junos engineer proposes the following response: Use then discard in the matching firewall filter term. Which concept or operating procedure is best illustrated?

  1. Protect Routing Engine lo0
  2. Policy next policy
  3. Firewall filter discard action
  4. Input versus output attachment

Explanation

Correct Answer

C:

Discard drops matched packets without explicitly returning an unreachable response. This meets the stated need for firewall filter discard action.

Incorrect Answers

A:

The protect routing engine lo0 scenario has a different requirement: A loopback input filter can protect traffic destined for the Routing Engine while preserving required protocol exchanges. It does not directly meet the firewall filter discard action need in this question.

B:

The policy next policy scenario has a different requirement: Next policy transfers evaluation to the next policy statement rather than finishing with a decision. It does not directly meet the firewall filter discard action need in this question.

D:

The input versus output attachment scenario has a different requirement: The input direction applies filter logic to packets entering the associated interface. It does not directly meet the firewall filter discard action need in this question.

Junos, Associate (JNCIA-Junos) (JN0-106) Practice Tests