Question 30
A service-provider operations test targets: Two provider core routers form an IS-IS L1 adjacency but do not exchange a prefix from another area because the engineer assumes L1 routers have universal interarea visibility. Which result is required?
Explanation
Correct Answer
A test prefix from the remote area appears in the intended routing table without unintended leaking of unrelated routes. This confirms the approved response: Introduce the appropriate L1/L2 boundary or L2 route advertisement and review the required reachability design. It is relevant because: IS-IS Level 1 routing remains within an area, while Level 2 carries interarea reachability.
Incorrect Answers
During restart testing, other routers avoid the node for transit until its forwarding state is ready. This would validate ANOTHER scenario: A provider enables IS-IS overload on a recovering core node then removes the flag before the full route database is synchronized, leading to transient transit blackholes. The specific correction here is: Introduce the appropriate L1/L2 boundary or L2 route advertisement and review the required reachability design.
Route calculation shifts the test prefix to the expected lower-cost path without interrupting control adjacencies. This would validate ANOTHER scenario: An IS-IS L2 router forms adjacency but traffic chooses a high-latency optical link because the interface metric was left at a low default. The specific correction here is: Introduce the appropriate L1/L2 boundary or L2 route advertisement and review the required reachability design.
During a simulated link withdrawal, surviving links meet congestion and QoS objectives under measured peak load. This would validate ANOTHER scenario: A core routing node performs maintenance with all traffic temporarily pinned to one uplink, exceeding the designed capacity even though connectivity stays up. The specific correction here is: Introduce the appropriate L1/L2 boundary or L2 route advertisement and review the required reachability design.