Question 430
A service-provider operations test targets: An OSPF stub area loses its expected default route when an engineer configures stub mode on the access router but not consistently on the area border router. Which result is required?
Explanation
Correct Answer
The lab adjacency reaches Full and the stub router installs the designated default route. This confirms the approved response: Align stub-area configuration on the ABR and member routers and verify default advertisement. It is relevant because: OSPF area-type agreement is required for adjacency and stub routing behavior.
Incorrect Answers
Peering remains healthy and management attempts use a routable endpoint instead of a bare link-local address. This would validate ANOTHER scenario: An OSPFv3 deployment uses a link-local neighbor address and the monitoring system mistakenly treats it as globally reachable offlink for management. The specific correction here is: Align stub-area configuration on the ABR and member routers and verify default advertisement.
Valid component destinations work and an unassigned prefix does not loop indefinitely. This would validate ANOTHER scenario: An ABR summarizes branch routes into one large prefix that points into an area missing part of the address space, leading to a forwarding loop for unallocated addresses. The specific correction here is: Align stub-area configuration on the ABR and member routers and verify default advertisement.
Customer route queries show approved aggregate service routes but no internal infrastructure prefixes. This would validate ANOTHER scenario: An edge router injects all OSPF internals into BGP without tagging or policy, exposing infrastructure loopbacks to a customer upstream. The specific correction here is: Align stub-area configuration on the ABR and member routers and verify default advertisement.