McAfee-Secured Website

Exam Code: 156-315.82

Exam Name: Check Point Certified Security Expert - R82 (CCSE)

Certification Provider: Checkpoint

Corresponding Certification: CCSE R82

Questions & Answers

100% Checkpoint 156-315.82 Guaranteed Success With Testking Training Materials

Get Real 156-315.82 Exam Questions & Expert Verified Answers as Experienced on the Real Exam!

Questions & Answers

100 Questions & Answers with Testing Engine

"Check Point Certified Security Expert - R82 (CCSE) Exam", also known as 156-315.82 exam, is a Checkpoint certification exam.

Pass your tests with the always up-to-date 156-315.82 Exam Engine. Your 156-315.82 training materials keep you at the head of the pack!

Satisfaction Guaranteed

Money Back Guarantee

Testking provides hassle-free money back guarantee with our products. That is because we have 100% trust in the abilities of our professional and experience product team, and our record is a proof of that.

99.6% PASS RATE
Was: $137.49
Now: $124.99

Checkpoint 156-315.82 Practice Test 44

Question 430

Two R82 gateways are planned to protect IPv6 networks over Site-to-Site IPsec. A legacy design document requests IKEv1 aggressive mode, although the protected flows use IPv6 on both ends. An alternate diagnosis concerns the requirement to analyze failures caused by inconsistent encryption algorithms, for which a colleague suggests compare phase settings, algorithms, and proposals on both peers. Based on the recorded symptoms, which corrective step should have priority?

  1. Verify phase-two traffic selectors and matching policy rules
  2. Configure both gateways in the appropriate Site-to-Site VPN community
  3. Use IKEv2 for IPv6 VPN negotiations
  4. Compare phase settings, algorithms, and proposals on both peers

Explanation

Correct Answer

C:

R82 IPv6 VPN uses IKEv2. This directly addresses the documented incident evidence.

Incorrect Answers

A:

Data associations still need matching selectors and permitted traffic, yet that applies to troubleshoot a stable VPN phase-one but no protected data rather than the observed issue.

B:

Site-to-Site communities define gateway membership and tunnel policy; this does not resolve the observed condition.

D:

Both IKE/IPsec peers must agree on compatible proposals, but the current evidence calls for a different R82 operation.

Question 431

A password-spray alert should fire after ten different source IPs target a server, not after ten retries from the same source. SmartEvent currently counts every matching log. A proposed change would be to configure a Time Object for the event definition, which addresses the different requirement to focus on logins outside permitted working hours. Which action instead addresses the observed incident?

  1. Configure a SmartEvent threshold of log count and seconds
  2. Use unique values of the desired log field when counting
  3. Configure a Time Object for the event definition
  4. Configure Event Format field display mapping

Explanation

Correct Answer

B:

Unique-field counting measures distinct source values. This directly addresses the documented incident evidence.

Incorrect Answers

A:

SmartEvent threshold combines frequency and interval, yet that applies to create an alert after repeated matching logs in a time window rather than the observed issue.

C:

SmartEvent can use time objects for working-hours events, but the current evidence calls for a different R82 operation.

D:

Event Format determines which event details are displayed; this does not resolve the observed condition.

Question 432

A Check Point gateway still runs R80.30 and the change ticket requests R82 directly. The team has not confirmed whether this source version can follow a single upgrade step, and the package is not yet installed. A proposed change would be to use CPUSE for a compatible management-server in-place upgrade, which addresses the different requirement to perform a management in-place upgrade with supported tooling. Which action instead addresses the observed incident?

  1. Use CPUSE for a compatible management-server in-place upgrade
  2. Use SmartConsole Central Deployment where supported
  3. Choose a documented management Upgrade or Migration method
  4. Consult the R82 supported upgrade methods by component type

Explanation

Correct Answer

D:

Upgrade method support differs for gateways and management servers. This directly addresses the documented incident evidence.

Incorrect Answers

A:

CPUSE supports management in-place upgrade workflows, but the current evidence calls for a different R82 operation.

B:

Central Deployment is the documented gateway best practice; this does not resolve the observed condition.

C:

Management databases use their supported upgrade and migration workflows, yet that applies to plan an upgrade of a management-server database rather than the observed issue.

Question 433

A replacement management server is deployed at a different IP address than its predecessor. Managed gateways and related log servers must reconnect after the database import, and the upgrade guide requires additional control-plane planning for changed addresses. The operator must distinguish this from a separate requirement to prevent both old and new management hosts from competing. Which supported change follows from the actual evidence rather than that alternative hypothesis?

  1. Connect the new management host on the intended network
  2. Export on the source and import on the destination
  3. Plan control-plane addressing and reconnect managed gateways correctly
  4. Disconnect the retired source before activating its replacement

Explanation

Correct Answer

C:

A migration needs correct management connectivity and trusted identity. This directly addresses the documented incident evidence.

Incorrect Answers

A:

The new server needs appropriate network connectivity to manage gateways, yet that applies to bring the replacement management server online after import rather than the observed issue.

B:

Management migration preserves the database through export/import; this does not resolve the observed condition.

D:

Controlled cutover prevents conflicting management authorities, but the current evidence calls for a different R82 operation.

Question 434

During an ElasticXL architecture review, an engineer assumes every member has an independent external policy object and a separate public traffic VIP. The site has a healthy SMO and one logical R82 gateway object. The controls that address the separate requirement to distribute the first member software to newly joined nodes are already working as designed, and the change ticket must not disturb them. Which R82 action addresses the remaining symptom?

  1. Allow the automatic image/configuration clone from SMO
  2. Expect the SMO to accept and distribute traffic to members
  3. Create a new Site while admitting the pending appliance
  4. Remove it then add as a pending member to the target site

Explanation

Correct Answer

B:

The SMO handles distribution to other site members. This directly addresses the documented incident evidence.

Incorrect Answers

A:

ElasticXL copies the SMO image and settings to added members, but the current evidence calls for a different R82 operation.

C:

A new site is used to establish High Availability sites; this does not resolve the observed condition.

D:

The documented workflow removes and re-adds a node to the chosen site, yet that applies to move a cluster member from one site to another rather than the observed issue.

Question 435

A secondary R82 Management Server has just been added to a healthy deployment. Its database has not yet completed the initial HA synchronization and the primary remains active. The technician proposes activating both servers to speed provisioning. The controls that address the separate requirement to correct a collision where both Management Servers report Active are already working as designed, and the change ticket must not disturb them. Which R82 action addresses the remaining symptom?

  1. Leave the newly defined secondary Management Server in Standby
  2. Treat the first installed management server as the primary
  3. Open the Standby Management Server in read-only SmartConsole mode
  4. Use Management HA actions to set one server to Standby

Explanation

Correct Answer

A:

Secondary management servers start in Standby by default. This directly addresses the documented incident evidence.

Incorrect Answers

B:

Installation sequence defines primary versus secondary roles, yet that applies to identify the initial primary management server during installation rather than the observed issue.

C:

Standby permits inspection without competing configuration changes; this does not resolve the observed condition.

D:

One Active server is required for a consistent normal HA state, but the current evidence calls for a different R82 operation.

Question 436

An administrator imports a cloud-service Updatable Object and tries nesting it inside a traditional network group to share it across several Access Control rules. The editor rejects the nesting. An alternate diagnosis concerns the requirement to confirm an external address feed was refreshed successfully, for which a colleague suggests search Logs & Events for the named object and status Succeeded. Based on the recorded symptoms, which corrective step should have priority?

  1. Use an Updatable Object as source or destination of an HTTPS rule
  2. Let the Updatable Object update on the Security Gateway
  3. Search Logs & Events for the named object and status Succeeded
  4. Reference the object directly in eligible policy rule columns

Explanation

Correct Answer

D:

Updatable Objects can be used directly in supported policy fields. This directly addresses the documented incident evidence.

Incorrect Answers

A:

HTTPS Inspection supports Updatable Objects in matching fields; this does not resolve the observed condition.

B:

An Updatable Object membership refresh does not require policy reinstall, yet that applies to apply updated provider address membership without reinstallation rather than the observed issue.

C:

Successful update logs provide feed-specific operational evidence, but the current evidence calls for a different R82 operation.

Question 437

A tunnel to an interoperable third-party firewall never establishes an IKE SA. Packet capture shows IKE negotiation messages are exchanged but fail authentication; no phase-two selector negotiation starts. An alternate diagnosis concerns the requirement to authenticate a third-party IPsec peer with a shared secret, for which a colleague suggests configure matching pre-shared keys on both VPN peers. Based on the recorded symptoms, which corrective step should have priority?

  1. Configure matching pre-shared keys on both VPN peers
  2. Verify phase-two traffic selectors and matching policy rules
  3. Review IKE negotiation settings and authentication on both peers
  4. Configure accepted peer certificates and trusted issuing authority

Explanation

Correct Answer

C:

IKE agreement and authentication are prerequisites for tunnel setup. This directly addresses the documented incident evidence.

Incorrect Answers

A:

Both sides need consistent configured IKE authentication secrets, but the current evidence calls for a different R82 operation.

B:

Data associations still need matching selectors and permitted traffic, yet that applies to troubleshoot a stable VPN phase-one but no protected data rather than the observed issue.

D:

Certificate authentication relies on valid identities and trust; this does not resolve the observed condition.

Question 438

The compliance officer has completed the R82 framework assessment and must send management a printable PDF of noncompliant controls and the compliance scoring summary. Raw traffic logs are not the requested evidence artifact. A preliminary suggestion is to open Logs & Events and select Reports. The incident evidence instead points to a different control within the same R82 subsystem. What is the most relevant action?

  1. Generate a Compliance Blade report in the Reports view
  2. Review Regulatory Compliance requirements and scores
  3. Activate the Compliance Software Blade
  4. Open Logs & Events and select Reports

Explanation

Correct Answer

A:

Compliance reporting supports a PDF output. This directly addresses the documented incident evidence.

Incorrect Answers

B:

Compliance maps checks to selected regulatory requirements; this does not resolve the observed condition.

C:

Compliance evaluates Check Point security best practices, yet that applies to enable rule and gateway best-practice assessment rather than the observed issue.

D:

Reports summarize monitored activity for presentation, but the current evidence calls for a different R82 operation.

Question 439

A security management server itself needs an R82 in-place update using a supported path. The operator proposes gateway Central Deployment because it updated the network firewalls yesterday. The operator must distinguish this from a separate requirement to plan an upgrade of a management-server database. Which supported change follows from the actual evidence rather than that alternative hypothesis?

  1. Choose a documented management Upgrade or Migration method
  2. Consult the R82 supported upgrade methods by component type
  3. Capture a supported backup/snapshot and upgrade plan
  4. Use CPUSE for a compatible management-server in-place upgrade

Explanation

Correct Answer

D:

CPUSE supports management in-place upgrade workflows. This directly addresses the documented incident evidence.

Incorrect Answers

A:

Management databases use their supported upgrade and migration workflows, but the current evidence calls for a different R82 operation.

B:

Upgrade method support differs for gateways and management servers, yet that applies to assess available upgrade pathways before execution rather than the observed issue.

C:

Recovery artifacts make a failed upgrade safer to reverse; this does not resolve the observed condition.

Question 440

A scheduled R82 management database export is about to begin, but several engineers retain open SmartConsole sessions against the source. Publication decisions have been made and edits must now remain stable until the archive completes. An alternate diagnosis concerns the requirement to move an R82 Management Server database to another R82 host, for which a colleague suggests export on the source and import on the destination. Based on the recorded symptoms, which corrective step should have priority?

  1. Invoke migrate_server export from the prescribed scripts directory
  2. Close SmartConsole GUI clients on the source server
  3. Export on the source and import on the destination
  4. Connect with SmartConsole and inspect imported configuration

Explanation

Correct Answer

B:

Closing clients avoids concurrent management modifications. This directly addresses the documented incident evidence.

Incorrect Answers

A:

The management migration tool serializes the management database; this does not resolve the observed condition.

C:

Management migration preserves the database through export/import, but the current evidence calls for a different R82 operation.

D:

Post-import SmartConsole inspection confirms objects and policies, yet that applies to validate the database after migration completes rather than the observed issue.

Check Point Certified Security Expert - R82 (CCSE) (156-315.82) Practice Tests