McAfee-Secured Website

Exam Code: 156-315.82

Exam Name: Check Point Certified Security Expert - R82 (CCSE)

Certification Provider: Checkpoint

Corresponding Certification: CCSE R82

Questions & Answers

100% Checkpoint 156-315.82 Guaranteed Success With Testking Training Materials

Get Real 156-315.82 Exam Questions & Expert Verified Answers as Experienced on the Real Exam!

Questions & Answers

100 Questions & Answers with Testing Engine

"Check Point Certified Security Expert - R82 (CCSE) Exam", also known as 156-315.82 exam, is a Checkpoint certification exam.

Pass your tests with the always up-to-date 156-315.82 Exam Engine. Your 156-315.82 training materials keep you at the head of the pack!

Satisfaction Guaranteed

Money Back Guarantee

Testking provides hassle-free money back guarantee with our products. That is because we have 100% trust in the abilities of our professional and experience product team, and our record is a proof of that.

99.6% PASS RATE
Was: $137.49
Now: $124.99

Checkpoint 156-315.82 Practice Test 23

Question 220

Two R82 gateways are planned to protect IPv6 networks over Site-to-Site IPsec. A legacy design document requests IKEv1 aggressive mode, although the protected flows use IPv6 on both ends. What IKE choice is supported for IPv6 VPN negotiation?

  1. Review IKE negotiation settings and authentication on both peers
  2. Configure matching pre-shared keys on both VPN peers
  3. Configure the gateway Link Selection settings
  4. Use IKEv2 for IPv6 VPN negotiations

Explanation

Correct Answer

D:

Use IKEv2 for IPv6 Site-to-Site VPN traffic; R82 IPv6 protection does not support IKEv1 aggressive mode.

Incorrect Answers

A:

General IKE troubleshooting does not change the protocol support requirement for IPv6 VPNs.

B:

Matching pre-shared keys can authenticate IKE but cannot make IKEv1 aggressive mode supported for IPv6.

C:

Local Link Selection configuration does not enable an unsupported IKE generation for IPv6.

Question 221

An R82 SmartEvent rule correctly identifies a pattern but fires after only two occurrences, while the SOC requires an alert after a higher number within the same time window. The event logic and reaction should stay unchanged. A proposed change would be to configure Event Format field display mapping, which addresses the different requirement to display only relevant fields in an event detail view. Which action instead addresses the observed incident?

  1. Configure Event Format field display mapping
  2. Configure a suitable event exception or exclusion
  3. Point the Correlation Unit at the intended production Log Servers
  4. Edit the relevant Event Definition threshold

Explanation

Correct Answer

D:

The event definition controls the correlation trigger. This directly addresses the documented incident evidence.

Incorrect Answers

A:

Event Format determines which event details are displayed, but the current evidence calls for a different R82 operation.

B:

Event definitions support exceptions and exclusions for noisy patterns; this does not resolve the observed condition.

C:

Correlation units read relevant configured log sources, yet that applies to separate log storage from SmartEvent analysis rather than the observed issue.

Question 222

A central upgrade job was configured against ten gateways, but the approved ticket lists only six of them. Operators want to avoid changes to unapproved sites without altering the package contents. The controls that address the separate requirement to target every member of a gateway cluster for an upgrade are already working as designed, and the change ticket must not disturb them. Which R82 action addresses the remaining symptom?

  1. Deploy packages to the explicitly selected target objects
  2. Select the cluster object in Central Deployment
  3. Select Gateway & Server objects under Central Deployment
  4. Use supported Central Deployment parallel target selection

Explanation

Correct Answer

A:

Central Deployment scopes actions to selected targets. This directly addresses the documented incident evidence.

Incorrect Answers

B:

Central Deployment supports choosing a cluster object, but the current evidence calls for a different R82 operation.

C:

The deployment selection identifies actual upgrade targets, yet that applies to choose target appliances for a SmartConsole hotfix push rather than the observed issue.

D:

Central Deployment can process several supported targets; this does not resolve the observed condition.

Question 223

An upgrade checklist instructs the engineer to capture the full R82 Management Server database using the supported migration utility. The operator instead exports only an Access Control policy file. The controls that address the separate requirement to import the exported R82 database on the replacement server are already working as designed, and the change ticket must not disturb them. Which R82 action addresses the remaining symptom?

  1. Export on the source and import on the destination
  2. Invoke migrate_server export from the prescribed scripts directory
  3. Back up the current management configuration first
  4. Invoke migrate_server import for the exported archive

Explanation

Correct Answer

B:

The management migration tool serializes the management database. This directly addresses the documented incident evidence.

Incorrect Answers

A:

Management migration preserves the database through export/import, yet that applies to move an R82 Management Server database to another R82 host rather than the observed issue.

C:

The R82 migration procedure begins with source backups; this does not resolve the observed condition.

D:

The migration import restores the exported management database, but the current evidence calls for a different R82 operation.

Question 224

A new capacity requirement calls for another supported appliance in the existing R82 ElasticXL cluster. The Security Management Server should still see one logical gateway identity and existing policy. An alternate diagnosis concerns the requirement to apply a security policy to an ElasticXL cluster, for which a colleague suggests install policy on the cluster single gateway object. Based on the recorded symptoms, which corrective step should have priority?

  1. Add supported members through ElasticXL admission and cloning
  2. Use insights or show cluster info provision live
  3. Review supported platform and cluster membership limits
  4. Install policy on the cluster single gateway object

Explanation

Correct Answer

A:

ElasticXL is designed to scale membership under one gateway object. This directly addresses the documented incident evidence.

Incorrect Answers

B:

ElasticXL provides member onboarding and clone status commands; this does not resolve the observed condition.

C:

ElasticXL has documented platform and membership constraints, yet that applies to check membership count and topology before scaling rather than the observed issue.

D:

The SMO represents the entire cluster for policy management, but the current evidence calls for a different R82 operation.

Question 225

The Active R82 Management Server fails and is confirmed offline. The Standby is synchronized and reachable by administrators. Security Gateways continue using the installed policy, but urgent management changes are required. An alternate diagnosis concerns the requirement to investigate whether an HA role change completed, for which a colleague suggests verify exactly one Active and remaining Standby status. Based on the recorded symptoms, which corrective step should have priority?

  1. Use Management HA actions to set one server to Standby
  2. Verify exactly one Active and remaining Standby status
  3. Use the Active Management Server for write operations
  4. Initiate changeover so a healthy standby becomes Active

Explanation

Correct Answer

D:

A controlled management changeover restores an Active management server. This directly addresses the documented incident evidence.

Incorrect Answers

A:

One Active server is required for a consistent normal HA state; this does not resolve the observed condition.

B:

One Active peer is the expected result of controlled changeover, but the current evidence calls for a different R82 operation.

C:

Only the Active server accepts normal management changes, yet that applies to make configuration changes while the management pair remains healthy rather than the observed issue.

Question 226

An internal migration needs a static address translation only for inbound sessions to one legacy server. The team must avoid creating a symmetric outbound mapping for every flow. A preliminary suggestion is to open Security Policies > Access Control > NAT. The incident evidence instead points to a different control within the same R82 subsystem. What is the most relevant action?

  1. Create a Manual NAT rule matching the specified address pair
  2. Open Security Policies > Access Control > NAT
  3. Create an appropriate one-direction Manual NAT policy rule
  4. Use the Translated Services column in a Manual NAT rule

Explanation

Correct Answer

C:

Manual NAT supports direction-specific static translation. This directly addresses the documented incident evidence.

Incorrect Answers

A:

Manual NAT can match both original source and destination, yet that applies to restrict address translation to a specific source and destination rather than the observed issue.

B:

The Access Control NAT policy contains manual translation rules, but the current evidence calls for a different R82 operation.

D:

Manual NAT can translate services as well as addresses; this does not resolve the observed condition.

Question 227

Two external interfaces provide different VPN qualities and a service-specific policy must select a different link for latency-sensitive traffic than for bulk transfer. Static routing still works for the peer. Which R82 VPN feature addresses service-aware egress?

  1. Review Service Based Link Selection policies
  2. Configure the gateway Link Selection settings
  3. Confirm chosen local interface and peer-advertised address
  4. Use a Star VPN community with the hub as center

Explanation

Correct Answer

A:

Configure Service Based Link Selection for the relevant service-specific VPN traffic and eligible links.

Incorrect Answers

B:

Basic Link Selection sets gateway addresses and interfaces but does not by itself define per-service behavior.

C:

Checking selected interface confirms current egress but does not establish a new service-based policy.

D:

Changing mesh/star community topology is unrelated to which link carries a particular service.

Question 228

Compliance reviewers ask why a managed gateway’s security rulebase fails specific Check Point best practices. Analysts have only log searches and cannot see configuration-grade rule findings. The controls that address the separate requirement to separate log storage from SmartEvent analysis are already working as designed, and the change ticket must not disturb them. Which R82 action addresses the remaining symptom?

  1. Point the Correlation Unit at the intended production Log Servers
  2. Generate a Compliance Blade report in the Reports view
  3. Activate the Compliance Software Blade
  4. Review Regulatory Compliance requirements and scores

Explanation

Correct Answer

C:

Compliance evaluates Check Point security best practices. This directly addresses the documented incident evidence.

Incorrect Answers

A:

Correlation units read relevant configured log sources, but the current evidence calls for a different R82 operation.

B:

Compliance reporting supports a PDF output, yet that applies to prepare a PDF summary of compliance findings rather than the observed issue.

D:

Compliance maps checks to selected regulatory requirements; this does not resolve the observed condition.

Question 229

Central Deployment reports that a Jumbo installation completed on the selected gateway. The ticket requires evidence of the exact resulting package level, not only the absence of errors in the SmartConsole Tasks panel. The operator must distinguish this from a separate requirement to move a gateway to a selected supported major version. Which supported change follows from the actual evidence rather than that alternative hypothesis?

  1. Review the package installation and gateway version result
  2. Use Central Deployment Version Upgrade to Specific Major Version
  3. Select Gateway & Server objects under Central Deployment
  4. Use CPUSE with the applicable local/cloud package source

Explanation

Correct Answer

A:

Actual installed version proves the deployment target state. This directly addresses the documented incident evidence.

Incorrect Answers

B:

Central Deployment offers target-version selection, but the current evidence calls for a different R82 operation.

C:

The deployment selection identifies actual upgrade targets, yet that applies to choose target appliances for a SmartConsole hotfix push rather than the observed issue.

D:

CPUSE performs Gaia software package installation and upgrades; this does not resolve the observed condition.

Question 230

The old management system exported its R82 database and the archive was copied to the new cleanly installed target. The target operator accidentally starts another export rather than loading the archive. An alternate diagnosis concerns the requirement to move an R82 Management Server database to another R82 host, for which a colleague suggests export on the source and import on the destination. Based on the recorded symptoms, which corrective step should have priority?

  1. Export on the source and import on the destination
  2. Invoke migrate_server import for the exported archive
  3. Check imported policies, objects, and management settings
  4. Invoke migrate_server export from the prescribed scripts directory

Explanation

Correct Answer

B:

The migration import restores the exported management database. This directly addresses the documented incident evidence.

Incorrect Answers

A:

Management migration preserves the database through export/import, but the current evidence calls for a different R82 operation.

C:

Database content inspection tests the outcome of a migration; this does not resolve the observed condition.

D:

The management migration tool serializes the management database, yet that applies to run management database export with the R82 migration tool rather than the observed issue.

Check Point Certified Security Expert - R82 (CCSE) (156-315.82) Practice Tests