Question 1
At a public university network in Madison, two access switches must share a nonrouted user VLAN through the firewall while retaining security-zone inspection. The change affects learning systems. Which configuration step most directly meets the stated requirement?
Explanation
Correct Answer
At a public university network in Madison, this directly addresses layer 2 interfaces at the described site: Configure matching Layer 2 Ethernet interfaces, assign the VLAN and appropriate zones, and commit. The acceptance check is concrete: same-VLAN hosts exchange approved frames through the inspected firewall path without an IP gateway on those ports.
Incorrect Answers
The alternative would keep the bridge VLANs distinct and add an intentional routed gateway instead of assuming Layer 2 forwarding routes between VLANs; its own acceptance check is: Same-VLAN traffic works and inter-VLAN traffic crosses the designated routed gateway under policy. Although both choices involve layer 2 interfaces, this case requires the intervention: Configure matching Layer 2 Ethernet interfaces, assign the VLAN and appropriate zones, and commit. Its required outcome is: Same-VLAN hosts exchange approved frames through the inspected firewall path without an IP gateway on those ports. The first test could pass while this distinct configuration remains unverified.
The alternative would add a suitable aggregate Ethernet Layer 3 subinterface for the VLAN and bind its router and zone to address aggregate ethernet interfaces. Its acceptance test is: The tagged VLAN is routed through the aggregate subinterface and member ports do not have conflicting routed IP settings. This case instead requires layer 2 interfaces, implemented by configure matching Layer 2 Ethernet interfaces, assign the VLAN and appropriate zones, and commit; the deciding test is: Same-VLAN hosts exchange approved frames through the inspected firewall path without an IP gateway on those ports. The alternate control does not establish the requested outcome.
The alternative would add an 802.1Q Layer 2 subinterface for tag 140 and place it in the matching VLAN and zone; its own acceptance check is: A capture shows tag 140 isolated from guest frames while approved traffic crosses the paired Layer 2 segment. Although both choices involve layer 2 interfaces, this case requires the intervention: Configure matching Layer 2 Ethernet interfaces, assign the VLAN and appropriate zones, and commit. Its required outcome is: Same-VLAN hosts exchange approved frames through the inspected firewall path without an IP gateway on those ports. The first test could pass while this distinct configuration remains unverified.