McAfee-Secured Website

Exam Code: JN0-106

Exam Name: Junos, Associate (JNCIA-Junos)

Certification Provider: Juniper

Corresponding Certification: JNCIA-Junos

100% Juniper JN0-106 Guaranteed Success With Testking Training Materials

Get Real JN0-106 Exam Questions & Expert Verified Answers as Experienced on the Real Exam!

98 Questions & Answers with Testing Engine

"Junos, Associate (JNCIA-Junos) Exam", also known as JN0-106 exam, is a Juniper certification exam.

Pass your tests with the always up-to-date JN0-106 Exam Engine. Your JN0-106 training materials keep you at the head of the pack!

Satisfaction Guaranteed

Money Back Guarantee

Testking provides hassle-free money back guarantee with our products. That is because we have 100% trust in the abilities of our professional and experience product team, and our record is a proof of that.

99.6% PASS RATE
Was: $137.49
Now: $124.99

Juniper JN0-106 Practice Test 1

Question 1

A campus Ethernet link connects several hosts through an old shared repeater, and simultaneous transmissions cause collisions. Which configuration or troubleshooting action most directly meets the need?

  1. Identify the subnet mask as a /25 prefix.
  2. Learn the default router from IPv6 Router Advertisements rather than using ARP.
  3. Map traffic into appropriate egress queues and configure a suitable class-of-service scheduler.
  4. Replace the repeater with a switch that provides a separate collision domain for each full-duplex port.

Explanation

Correct Answer

D:

A switch separates contention at each port, whereas a hub repeats traffic into one shared collision domain. This meets the stated need for collision-domain isolation.

Incorrect Answers

A:

The subnet mask /25 interpretation scenario has a different requirement: The first 25 mask bits are set to one: 24 bits in the first three octets and one more in 128. It does not directly meet the collision-domain isolation need in this question.

B:

The ipv6 default-router discovery scenario has a different requirement: IPv6 Router Advertisements carry default-router information that hosts can use for off-link forwarding. It does not directly meet the collision-domain isolation need in this question.

C:

The cos scheduling queues scenario has a different requirement: CoS queuing and scheduling influence which packets receive transmission opportunity during congestion. It does not directly meet the collision-domain isolation need in this question.

Question 2

Within Networking Fundamentals, a Junos engineer proposes the following response: Replace the repeater with a switch that provides a separate collision domain for each full-duplex port. Which concept or operating procedure is best illustrated?

  1. Collision-domain isolation
  2. Subnet mask /25 interpretation
  3. IPv6 default-router discovery
  4. CoS scheduling queues

Explanation

Correct Answer

A:

A switch separates contention at each port, whereas a hub repeats traffic into one shared collision domain. This meets the stated need for collision-domain isolation.

Incorrect Answers

B:

The subnet mask /25 interpretation scenario has a different requirement: The first 25 mask bits are set to one: 24 bits in the first three octets and one more in 128. It does not directly meet the collision-domain isolation need in this question.

C:

The ipv6 default-router discovery scenario has a different requirement: IPv6 Router Advertisements carry default-router information that hosts can use for off-link forwarding. It does not directly meet the collision-domain isolation need in this question.

D:

The cos scheduling queues scenario has a different requirement: CoS queuing and scheduling influence which packets receive transmission opportunity during congestion. It does not directly meet the collision-domain isolation need in this question.

Question 3

A campus Ethernet link connects several hosts through an old shared repeater, and simultaneous transmissions cause collisions. The proposed response is: Replace the repeater with a switch that provides a separate collision domain for each full-duplex port. Which explanation most accurately supports this response?

  1. A switch separates contention at each port, whereas a hub repeats traffic into one shared collision domain.
  2. The first 25 mask bits are set to one: 24 bits in the first three octets and one more in 128.
  3. IPv6 Router Advertisements carry default-router information that hosts can use for off-link forwarding.
  4. CoS queuing and scheduling influence which packets receive transmission opportunity during congestion.

Explanation

Correct Answer

A:

A switch separates contention at each port, whereas a hub repeats traffic into one shared collision domain. This meets the stated need for collision-domain isolation.

Incorrect Answers

B:

The subnet mask /25 interpretation scenario has a different requirement: The first 25 mask bits are set to one: 24 bits in the first three octets and one more in 128. It does not directly meet the collision-domain isolation need in this question.

C:

The ipv6 default-router discovery scenario has a different requirement: IPv6 Router Advertisements carry default-router information that hosts can use for off-link forwarding. It does not directly meet the collision-domain isolation need in this question.

D:

The cos scheduling queues scenario has a different requirement: CoS queuing and scheduling influence which packets receive transmission opportunity during congestion. It does not directly meet the collision-domain isolation need in this question.

Question 4

Within Networking Fundamentals, a technician selects this approach: Replace the repeater with a switch that provides a separate collision domain for each full-duplex port. Which original requirement or fault would most directly justify it?

  1. An IPv4 endpoint uses mask 255.255.255.128 and an engineer must state its prefix length.
  2. A campus Ethernet link connects several hosts through an old shared repeater, and simultaneous transmissions cause collisions.
  3. A host must learn which on-link IPv6 router can forward packets to destinations outside its subnet.
  4. A router must prefer delay-sensitive traffic without allowing background transfers to monopolize the egress link.

Explanation

Correct Answer

B:

A switch separates contention at each port, whereas a hub repeats traffic into one shared collision domain. This meets the stated need for collision-domain isolation.

Incorrect Answers

A:

The subnet mask /25 interpretation scenario has a different requirement: The first 25 mask bits are set to one: 24 bits in the first three octets and one more in 128. It does not directly meet the collision-domain isolation need in this question.

C:

The ipv6 default-router discovery scenario has a different requirement: IPv6 Router Advertisements carry default-router information that hosts can use for off-link forwarding. It does not directly meet the collision-domain isolation need in this question.

D:

The cos scheduling queues scenario has a different requirement: CoS queuing and scheduling influence which packets receive transmission opportunity during congestion. It does not directly meet the collision-domain isolation need in this question.

Question 5

Two departments on the same switching fabric must not receive one another's Layer 2 broadcast traffic. Which configuration or troubleshooting action most directly meets the need?

  1. Select TCP with its connection establishment and acknowledgment behavior.
  2. Replace the repeater with a switch that provides a separate collision domain for each full-duplex port.
  3. Use the parent aggregate 2001:db8:100::/63 when advertising those adjacent subnets.
  4. Place the departments in separate VLANs and route between them only where policy permits.

Explanation

Correct Answer

D:

Each VLAN is a distinct Layer 2 broadcast domain; a router or Layer 3 interface is needed to cross that boundary. This meets the stated need for broadcast-domain boundary.

Incorrect Answers

A:

The tcp connection setup scenario has a different requirement: TCP is connection-oriented and provides ordered reliable delivery using sequence numbers, acknowledgments, and retransmission. It does not directly meet the broadcast-domain boundary need in this question.

B:

The collision-domain isolation scenario has a different requirement: A switch separates contention at each port, whereas a hub repeats traffic into one shared collision domain. It does not directly meet the broadcast-domain boundary need in this question.

C:

The ipv6 prefix summarization scenario has a different requirement: Those adjacent /64 networks share a 63-bit prefix and align on the correct /63 boundary. It does not directly meet the broadcast-domain boundary need in this question.

Question 6

Within Networking Fundamentals, a Junos engineer proposes the following response: Place the departments in separate VLANs and route between them only where policy permits. Which concept or operating procedure is best illustrated?

  1. TCP connection setup
  2. Broadcast-domain boundary
  3. Collision-domain isolation
  4. IPv6 prefix summarization

Explanation

Correct Answer

B:

Each VLAN is a distinct Layer 2 broadcast domain; a router or Layer 3 interface is needed to cross that boundary. This meets the stated need for broadcast-domain boundary.

Incorrect Answers

A:

The tcp connection setup scenario has a different requirement: TCP is connection-oriented and provides ordered reliable delivery using sequence numbers, acknowledgments, and retransmission. It does not directly meet the broadcast-domain boundary need in this question.

C:

The collision-domain isolation scenario has a different requirement: A switch separates contention at each port, whereas a hub repeats traffic into one shared collision domain. It does not directly meet the broadcast-domain boundary need in this question.

D:

The ipv6 prefix summarization scenario has a different requirement: Those adjacent /64 networks share a 63-bit prefix and align on the correct /63 boundary. It does not directly meet the broadcast-domain boundary need in this question.

Question 7

Two departments on the same switching fabric must not receive one another's Layer 2 broadcast traffic. The proposed response is: Place the departments in separate VLANs and route between them only where policy permits. Which explanation most accurately supports this response?

  1. TCP is connection-oriented and provides ordered reliable delivery using sequence numbers, acknowledgments, and retransmission.
  2. A switch separates contention at each port, whereas a hub repeats traffic into one shared collision domain.
  3. Those adjacent /64 networks share a 63-bit prefix and align on the correct /63 boundary.
  4. Each VLAN is a distinct Layer 2 broadcast domain; a router or Layer 3 interface is needed to cross that boundary.

Explanation

Correct Answer

D:

Each VLAN is a distinct Layer 2 broadcast domain; a router or Layer 3 interface is needed to cross that boundary. This meets the stated need for broadcast-domain boundary.

Incorrect Answers

A:

The tcp connection setup scenario has a different requirement: TCP is connection-oriented and provides ordered reliable delivery using sequence numbers, acknowledgments, and retransmission. It does not directly meet the broadcast-domain boundary need in this question.

B:

The collision-domain isolation scenario has a different requirement: A switch separates contention at each port, whereas a hub repeats traffic into one shared collision domain. It does not directly meet the broadcast-domain boundary need in this question.

C:

The ipv6 prefix summarization scenario has a different requirement: Those adjacent /64 networks share a 63-bit prefix and align on the correct /63 boundary. It does not directly meet the broadcast-domain boundary need in this question.

Question 8

Within Networking Fundamentals, a technician selects this approach: Place the departments in separate VLANs and route between them only where policy permits. Which original requirement or fault would most directly justify it?

  1. An application needs reliable ordered delivery over an established byte-stream connection.
  2. Two departments on the same switching fabric must not receive one another's Layer 2 broadcast traffic.
  3. A campus Ethernet link connects several hosts through an old shared repeater, and simultaneous transmissions cause collisions.
  4. A company wants to aggregate 2001:db8:100:0::/64 and 2001:db8:100:1::/64 without covering additional /64 networks.

Explanation

Correct Answer

B:

Each VLAN is a distinct Layer 2 broadcast domain; a router or Layer 3 interface is needed to cross that boundary. This meets the stated need for broadcast-domain boundary.

Incorrect Answers

A:

The tcp connection setup scenario has a different requirement: TCP is connection-oriented and provides ordered reliable delivery using sequence numbers, acknowledgments, and retransmission. It does not directly meet the broadcast-domain boundary need in this question.

C:

The collision-domain isolation scenario has a different requirement: A switch separates contention at each port, whereas a hub repeats traffic into one shared collision domain. It does not directly meet the broadcast-domain boundary need in this question.

D:

The ipv6 prefix summarization scenario has a different requirement: Those adjacent /64 networks share a 63-bit prefix and align on the correct /63 boundary. It does not directly meet the broadcast-domain boundary need in this question.

Question 9

Hosts in two different IP subnets must communicate, but only an unmanaged Layer 2 switch connects them. Which configuration or troubleshooting action most directly meets the need?

  1. Introduce a Layer 3 router or routed switch interface between the two IP networks.
  2. Classify the sequence as TCP's three-way connection handshake.
  3. Configure appropriate source NAT on the border device with required return-flow state.
  4. Choose the /25 route for that destination when both routes are active.

Explanation

Correct Answer

A:

Layer 3 forwarding selects an outgoing path using destination IP prefixes; ordinary Layer 2 switching does not route between subnets. This meets the stated need for router versus switch function.

Incorrect Answers

B:

The tcp three-way handshake scenario has a different requirement: The SYN, SYN-ACK, and ACK exchange synchronizes sequence numbers when a TCP connection is established. It does not directly meet the router versus switch function need in this question.

C:

The nat boundary translation scenario has a different requirement: Source NAT can translate private source addresses to an outward-facing address for Internet access. It does not directly meet the router versus switch function need in this question.

D:

The longest-prefix matching scenario has a different requirement: IP forwarding chooses the longest matching destination prefix, independent of the broader route's presence. It does not directly meet the router versus switch function need in this question.

Question 10

Within Networking Fundamentals, a Junos engineer proposes the following response: Introduce a Layer 3 router or routed switch interface between the two IP networks. Which concept or operating procedure is best illustrated?

  1. TCP three-way handshake
  2. NAT boundary translation
  3. Router versus switch function
  4. Longest-prefix matching

Explanation

Correct Answer

C:

Layer 3 forwarding selects an outgoing path using destination IP prefixes; ordinary Layer 2 switching does not route between subnets. This meets the stated need for router versus switch function.

Incorrect Answers

A:

The tcp three-way handshake scenario has a different requirement: The SYN, SYN-ACK, and ACK exchange synchronizes sequence numbers when a TCP connection is established. It does not directly meet the router versus switch function need in this question.

B:

The nat boundary translation scenario has a different requirement: Source NAT can translate private source addresses to an outward-facing address for Internet access. It does not directly meet the router versus switch function need in this question.

D:

The longest-prefix matching scenario has a different requirement: IP forwarding chooses the longest matching destination prefix, independent of the broader route's presence. It does not directly meet the router versus switch function need in this question.

Junos, Associate (JNCIA-Junos) (JN0-106) Practice Tests