McAfee-Secured Website

Exam Bundle

Exam Code: 200-301

Exam Name Cisco Certified Network Associate (CCNA)

Certification Provider: Cisco

Corresponding Certification: CCNA

Cisco 200-301 Bundle $44.99

100% Cisco 200-301 Guaranteed Success With Testking Training Materials

Get Real 200-301 Exam Questions & Expert Verified Answers as Experienced on the Real Exam!

  • Questions & Answers

    200-301 Questions & Answers

    760 Questions & Answers

    The ultimate exam preparation tool, Questions & Answers mirrors the actual 200-301 exam while allowing you to hone and measure every aspect of your test-taking ability.

  • 200-301 Video Course

    200-301 Video Course

    271 Video Lectures

    200-301 Video Course is developed by Cisco Professionals to help you pass the 200-301 exam.

    Description

    This course will improve your knowledge and skills required to pass Cisco Certified Network Associate (CCNA) exam.
  • Study Guide

    200-301 Study Guide

    1969 PDF Pages

    Developed by industry experts, this 1969-page guide spells out in painstaking detail all of the information you need to ace 200-301 exam.

Cisco Certified Network Associate (CCNA) (200-301) Practice Tests

Satisfaction Guaranteed

Money Back Guarantee

Testking provides hassle-free money back guarantee with our products. That is because we have 100% trust in the abilities of our professional and experience product team, and our record is a proof of that.

99.6% PASS RATE
Total Cost: $194.97
Bundle Price: $149.98

Purchase Individually

  • Questions & Answers

    Questions & Answers

    760 Questions

    $124.99
  • 200-301 Video Course

    Video Course

    271 Video Lectures

    $39.99
  • Study Guide

    Study Guide

    1969 PDF Pages

    $29.99

Cisco 200-301 Practice Test 26

Question 250

A multi-switch path at a municipal library passes VLAN 152 but drops VLAN 62, even though both end hosts have valid IPs. Which layer-two checks best isolate this failure?

  1. Assume that a VLAN exists on one switch so it must automatically pass every intermediate trunk
  2. Verify trunk operational status, permitted VLAN list and native VLAN consistency at both ends
  3. Ignore operational trunk mode and inspect only host DNS settings
  4. Disable both trunk interfaces permanently

Explanation

Correct Answer

B:

A multi-switch VLAN path depends on each trunk actually forming and carrying the relevant VLANs with consistent tagging.

Incorrect Answers

A:

VLAN existence is local and does not guarantee that every trunk forwards that VLAN.

C:

DNS is above Layer 2 and does not verify trunk formation or allowed VLAN lists.

D:

Turning down the trunks removes all connectivity rather than diagnosing one VLAN failure.

Question 251

Two distribution switches at a hospitality property carry VLAN 75 and VLAN 155 over one physical Ethernet interface. What mechanism distinguishes the VLANs in normal tagged frames?

  1. Depend on IP source port numbers to identify switch VLAN membership
  2. Use 802.1Q tagging to preserve VLAN identity across the trunk
  3. Encapsulate every VLAN solely by changing Ethernet source MAC addresses
  4. Use ARP instead of an 802.1Q VLAN identifier

Explanation

Correct Answer

B:

The 802.1Q header carries the VLAN ID so a receiving switch can place tagged frames in the proper VLAN.

Incorrect Answers

A:

TCP/UDP port numbers do not identify a Layer 2 VLAN.

C:

Ethernet MAC addresses are learned endpoint identities, not a reliable substitute for explicit trunk VLAN tags.

D:

ARP resolves IP-to-MAC mappings and does not label every trunked Ethernet frame.

Question 252

Both Cisco switchports use `switchport mode dynamic auto`, and neither initiates trunking negotiation. What should the network engineer change?

  1. Enable PortFast on the interswitch link
  2. Configure at least one switch end as trunk or dynamic desirable according to the design
  3. Change both ports to dynamic auto again
  4. Set every access port to VLAN 1

Explanation

Correct Answer

B:

Two DTP dynamic-auto peers do not initiate a trunk negotiation, so the link can remain access mode.

Incorrect Answers

A:

PortFast is intended for edge ports and does not negotiate a trunk.

C:

That repeats the same passive negotiation configuration.

D:

Reassigning unrelated hosts does not create the desired interswitch trunk.

Question 253

Two switches pass VLAN 60 on a physical trunk, but the operational output lists VLAN 60 as not forwarding due to spanning tree. What should be investigated first?

  1. Configure `ip helper-address` on the trunk
  2. The STP topology and blocked port state for VLAN 60
  3. Assign all access ports to VLAN 1
  4. Change every host DNS server

Explanation

Correct Answer

B:

A VLAN can be allowed and active yet not forward on a particular port because STP prevents loops.

Incorrect Answers

A:

An L2 trunk does not use DHCP relay to override STP blocking.

C:

That would disrupt VLAN segmentation without fixing the topology.

D:

DNS has no effect on the STP forwarding role.

Question 254

A Cisco IP phone connects to a switch access port and tags voice traffic for VLAN 230 while the attached PC uses untagged data VLAN 30. Which port feature supports this layout?

  1. Configure only an IP helper-address on a routed interface
  2. Configure voice VLAN 30 and data VLAN 230
  3. Configure only access VLAN 230 for all frames
  4. Configure access VLAN 30 and voice VLAN 230 on the phone-facing interface

Explanation

Correct Answer

D:

Voice VLAN operation permits the phone to tag voice frames while the PC uses the access data VLAN.

Incorrect Answers

A:

DHCP relay does not select voice/data Layer 2 VLAN membership.

B:

This reverses the approved VLAN roles for the phone and PC.

C:

This would combine voice and data into one VLAN instead of maintaining the intended segmentation.

Question 255

A campus guest VLAN 180 must reach only a firewall segment, while employee VLAN 10 uses a separate routed path. What trunk policy limits carriage?

  1. Turn off spanning tree as the isolation method
  2. Allow VLAN 180 on every switch trunk regardless of need
  3. Set all trunks to access mode VLAN 180
  4. Allow VLAN 180 only on trunks that are part of its approved path and exclude it elsewhere

Explanation

Correct Answer

D:

An explicit allowed VLAN list restricts Layer 2 guest broadcast-domain propagation.

Incorrect Answers

A:

STP is loop prevention, not a guest VLAN carriage policy.

B:

That extends the guest broadcast domain unnecessarily.

C:

Converting shared trunks to access mode breaks other tagged VLANs.

Question 256

An engineer expects an 802.1Q uplink, but `show interfaces Gi1/0/48 switchport` reports Operational Mode static access. Tagged VLANs cannot cross. What is the key issue?

  1. The switch needs an NTP server
  2. The port is operating as an access port and must be configured or negotiated as a trunk
  3. The link must disable CDP only
  4. The VLAN access ID should be set to zero

Explanation

Correct Answer

B:

VLAN tags for multiple networks require an operational trunk; the displayed access mode is conclusive.

Incorrect Answers

A:

Time synchronization does not enable 802.1Q VLAN tagging.

C:

CDP neighbors are not responsible for trunk operational mode.

D:

Zero is not a normal user VLAN assignment and would not establish a trunk.

Question 257

Two redundant uplink trunks carry the same user VLANs, but one uses native VLAN 50 and the other native VLAN 60. What configuration practice avoids misclassifying untagged frames after failover?

  1. Use the approved same native VLAN consistently on all participating trunk ends
  2. Use a random native VLAN on each end of each trunk
  3. Replace the trunk with DHCP helper addresses
  4. Disable trunks and rely on router advertisements

Explanation

Correct Answer

A:

Consistent native VLAN mapping avoids untagged data landing in different VLANs when a redundant link is used.

Incorrect Answers

B:

Random mismatch can leak or misclassify untagged traffic.

C:

DHCP relay cannot carry the Ethernet VLAN traffic itself.

D:

Router advertisements do not substitute for the intended Layer 2 trunk path.

Question 258

A switch connects to a firewall subinterface using explicit 802.1Q tags. DTP negotiation is unsupported on the firewall. What switch configuration is appropriate?

  1. Rely on dynamic auto on both ends
  2. Set the switchport to trunk mode and disable DTP negotiation if supported
  3. Configure the switch uplink as access in the voice VLAN
  4. Make the switch a DHCP server for the firewall

Explanation

Correct Answer

B:

The firewall expects explicit tagging and does not participate in Cisco Dynamic Trunking Protocol.

Incorrect Answers

A:

An unmanaged peer cannot negotiate a DTP trunk from passive auto mode.

C:

Access mode would not carry the multiple required tagged VLANs.

D:

DHCP service does not determine 802.1Q port mode.

Question 259

VLAN 75 is permitted on a trunk and exists on both switches, but traffic still fails. Which additional Layer 2 state must be verified before blaming IP routing?

  1. Assume the IP routing table always determines VLAN trunk forwarding
  2. Confirm the VLAN is in an STP forwarding state across the intended trunk
  3. Set every uplink as an access port for VLAN 1
  4. Disable MAC learning globally on both switches

Explanation

Correct Answer

B:

An allowed VLAN may still be blocked or nonforwarding by spanning tree or operational VLAN state.

Incorrect Answers

A:

Frames within a VLAN depend on Layer 2 trunk and STP behavior.

C:

That would remove the intended tagged VLAN path.

D:

MAC learning is needed for efficient Layer 2 forwarding.

Question 260

VLAN 120 works between two access switches but fails beyond a distribution trunk whose allowed list is 110,115,125. What specific trunk configuration is missing?

  1. Changing the DHCP lease time on VLAN 120
  2. An explicit allowance for VLAN 120 on the distribution trunk
  3. Changing the native VLAN to 120 without allowing it
  4. Renaming VLAN 120 in a spreadsheet

Explanation

Correct Answer

B:

The configured list filters VLAN 120 even if the trunk is operational and other VLANs pass.

Incorrect Answers

A:

DHCP lease duration does not override 802.1Q allowed-VLAN filtering.

C:

A native VLAN setting does not automatically solve all allowed-VLAN and STP conditions.

D:

Management documentation has no data-plane effect.