McAfee-Secured Website

Exam Code: 156-315.82

Exam Name: Check Point Certified Security Expert - R82 (CCSE)

Certification Provider: Checkpoint

Corresponding Certification: CCSE R82

Questions & Answers

100% Checkpoint 156-315.82 Guaranteed Success With Testking Training Materials

Get Real 156-315.82 Exam Questions & Expert Verified Answers as Experienced on the Real Exam!

Questions & Answers

100 Questions & Answers with Testing Engine

"Check Point Certified Security Expert - R82 (CCSE) Exam", also known as 156-315.82 exam, is a Checkpoint certification exam.

Pass your tests with the always up-to-date 156-315.82 Exam Engine. Your 156-315.82 training materials keep you at the head of the pack!

Satisfaction Guaranteed

Money Back Guarantee

Testking provides hassle-free money back guarantee with our products. That is because we have 100% trust in the abilities of our professional and experience product team, and our record is a proof of that.

99.6% PASS RATE
Was: $137.49
Now: $124.99

Checkpoint 156-315.82 Practice Test 64

Question 630

A management-HA changeover is reported as complete after planned maintenance. Operators can reach both R82 servers and want to ensure that the promotion did not leave a collision. The controls that address the separate requirement to recover administration when the active management node goes offline are already working as designed, and the change ticket must not disturb them. Which R82 action addresses the remaining symptom?

  1. Initiate changeover so a healthy standby becomes Active
  2. Select which node remains Active before resetting its peer
  3. Verify exactly one Active and remaining Standby status
  4. Review which database will be overwritten when setting Standby

Explanation

Correct Answer

C:

One Active peer is the expected result of controlled changeover. This directly addresses the documented incident evidence.

Incorrect Answers

A:

A controlled management changeover restores an Active management server, but the current evidence calls for a different R82 operation.

B:

Collision recovery should establish an authoritative Active node, yet that applies to resolve two active nodes safely during collision troubleshooting rather than the observed issue.

D:

Demoting a server to Standby overwrites its data from the Active peer; this does not resolve the observed condition.

Question 631

Only HTTPS traffic from a specified partner to one hosted service should have its destination TCP port rewritten; SSH to the same address must not be translated. The NAT object matches both sources currently. The operator must distinguish this from a separate requirement to restrict address translation to a specific source and destination. Which supported change follows from the actual evidence rather than that alternative hypothesis?

  1. Create a Manual NAT rule matching the specified address pair
  2. Match Original Services and set corresponding Translated Services
  3. Create translated objects, NAT rule, and matching Access Control rule
  4. Configure required Proxy ARP entries for the translated address

Explanation

Correct Answer

B:

Manual NAT can restrict rules by service and translated port. This directly addresses the documented incident evidence.

Incorrect Answers

A:

Manual NAT can match both original source and destination, but the current evidence calls for a different R82 operation.

C:

Manual NAT workflows also require valid translated objects and access, yet that applies to publish a server using a manually translated address rather than the observed issue.

D:

Manual NAT deployments require Proxy ARP where applicable; this does not resolve the observed condition.

Question 632

Two R82 managed Security Gateways have the VPN blade enabled and identical proposals, but the partner gateway never appears as a valid peer in traffic selection. SmartConsole shows no shared VPN community containing both nodes. An alternate diagnosis concerns the requirement to connect every gateway in a small trusted group directly to peers, for which a colleague suggests use a Mesh VPN community for peer relationships. Based on the recorded symptoms, which corrective step should have priority?

  1. Use a Mesh VPN community for peer relationships
  2. Use a Star VPN community with the hub as center
  3. Verify phase-two traffic selectors and matching policy rules
  4. Configure both gateways in the appropriate Site-to-Site VPN community

Explanation

Correct Answer

D:

Site-to-Site communities define gateway membership and tunnel policy. This directly addresses the documented incident evidence.

Incorrect Answers

A:

A Mesh model supports direct relationships among participating members, but the current evidence calls for a different R82 operation.

B:

A Star community models branch-to-center connectivity, yet that applies to connect multiple branches through a central hub site rather than the observed issue.

C:

Data associations still need matching selectors and permitted traffic; this does not resolve the observed condition.

Question 633

An administrator needs to move a member from ElasticXL Site 1 into Site 2. It already appears as a managed member of Site 1, so it is not pending for enrollment in the second site. The operator must distinguish this from a separate requirement to add a second ElasticXL Site for availability. Which supported change follows from the actual evidence rather than that alternative hypothesis?

  1. Add the pending appliance to the existing Site
  2. Create a new Site while admitting the pending appliance
  3. Remove it then add as a pending member to the target site
  4. Expect the SMO to accept and distribute traffic to members

Explanation

Correct Answer

C:

The documented workflow removes and re-adds a node to the chosen site. This directly addresses the documented incident evidence.

Incorrect Answers

A:

Adding to the existing site enables supported load sharing, yet that applies to increase capacity inside an existing ElasticXL Site rather than the observed issue.

B:

A new site is used to establish High Availability sites, but the current evidence calls for a different R82 operation.

D:

The SMO handles distribution to other site members; this does not resolve the observed condition.

Question 634

An active R82 management host fails beyond repair, but the standby was synchronized immediately before the incident. Operations need to retain the existing named objects and installed policy definitions without rebuilding them. A preliminary suggestion is to open the Standby Management Server in read-only SmartConsole mode. The incident evidence instead points to a different control within the same R82 subsystem. What is the most relevant action?

  1. Promote the synchronized standby management database
  2. Review which database will be overwritten when setting Standby
  3. Open the Standby Management Server in read-only SmartConsole mode
  4. Retain synchronized objects, rules, and management settings

Explanation

Correct Answer

A:

Synchronized standby retains management configuration for changeover. This directly addresses the documented incident evidence.

Incorrect Answers

B:

Demoting a server to Standby overwrites its data from the Active peer; this does not resolve the observed condition.

C:

Standby permits inspection without competing configuration changes, but the current evidence calls for a different R82 operation.

D:

Management HA keeps management configuration aligned on peers, yet that applies to explain the value of management database synchronization rather than the observed issue.

Question 635

A newly published internal server has a Manual NAT rule and a public address object, but connections still drop against the gateway rulebase. The NAT log shows the address translation matched. A preliminary suggestion is to configure required Proxy ARP entries for the translated address. The incident evidence instead points to a different control within the same R82 subsystem. What is the most relevant action?

  1. Configure required Proxy ARP entries for the translated address
  2. Use the Translated Services column in a Manual NAT rule
  3. Place the intended matching rule first in the NAT rule order
  4. Create translated objects, NAT rule, and matching Access Control rule

Explanation

Correct Answer

D:

Manual NAT workflows also require valid translated objects and access. This directly addresses the documented incident evidence.

Incorrect Answers

A:

Manual NAT deployments require Proxy ARP where applicable, but the current evidence calls for a different R82 operation.

B:

Manual NAT can translate services as well as addresses; this does not resolve the observed condition.

C:

Only the first matching Manual NAT rule is enforced, yet that applies to understand behavior when several Manual NAT rules could match rather than the observed issue.

Question 636

An R82 VPN community contains a permanent tunnel and the operator needs an alert when the tunnel stops responding. Tunnel status monitoring is available, but Logs & Events shows no reaction when the remote site goes offline. A preliminary suggestion is to configure the appropriate Permanent Tunnel setting. The incident evidence instead points to a different control within the same R82 subsystem. What is the most relevant action?

  1. Configure the appropriate Permanent Tunnel setting
  2. Enable permanent-tunnel tracking or alert behavior
  3. Use periodic tunnel-test responses to determine up status
  4. Use interoperable IKE Dead Peer Detection for supported permanent-tunnel monitoring

Explanation

Correct Answer

B:

Permanent tunnel monitoring can issue logs and alerts on failure. This directly addresses the documented incident evidence.

Incorrect Answers

A:

Permanent tunnels support configured monitoring between Check Point gateways, but the current evidence calls for a different R82 operation.

C:

Test packet responses are the basis for permanent tunnel status, yet that applies to verify a permanent VPN tunnel remains reachable rather than the observed issue.

D:

R82 Dead Peer Detection supports third-party gateways, while proprietary tunnel-test packets require Check Point peers; this does not resolve the observed condition.

Question 637

A new capacity requirement calls for another supported appliance in the existing R82 ElasticXL cluster. The Security Management Server should still see one logical gateway identity and existing policy. A proposed change would be to review supported platform and cluster membership limits, which addresses the different requirement to check membership count and topology before scaling. Which action instead addresses the observed incident?

  1. Review supported platform and cluster membership limits
  2. Create one Single Management Object for the entire cluster
  3. Add supported members through ElasticXL admission and cloning
  4. Run Gaia First Time Configuration Wizard on the first appliance only

Explanation

Correct Answer

C:

ElasticXL is designed to scale membership under one gateway object. This directly addresses the documented incident evidence.

Incorrect Answers

A:

ElasticXL has documented platform and membership constraints, but the current evidence calls for a different R82 operation.

B:

ElasticXL exposes one logical Security Gateway management object, yet that applies to manage an ElasticXL cluster as one logical gateway in SmartConsole rather than the observed issue.

D:

The first appliance establishes the configuration cloned to members; this does not resolve the observed condition.

Question 638

Two management servers each became Active during a link failure. An administrator proposes clicking Set Standby immediately on one node, but it holds unpublished rule changes absent from the other peer. A preliminary suggestion is to open the Standby Management Server in read-only SmartConsole mode. The incident evidence instead points to a different control within the same R82 subsystem. What is the most relevant action?

  1. Initiate changeover so a healthy standby becomes Active
  2. Use the Active Management Server for write operations
  3. Open the Standby Management Server in read-only SmartConsole mode
  4. Review which database will be overwritten when setting Standby

Explanation

Correct Answer

D:

Demoting a server to Standby overwrites its data from the Active peer. This directly addresses the documented incident evidence.

Incorrect Answers

A:

A controlled management changeover restores an Active management server, yet that applies to recover administration when the active management node goes offline rather than the observed issue.

B:

Only the Active server accepts normal management changes; this does not resolve the observed condition.

C:

Standby permits inspection without competing configuration changes, but the current evidence calls for a different R82 operation.

Question 639

A security gateway must rewrite both the source address of a partner request and its destination address toward an internal server for one connection. Automatic object NAT does not express the combined translation criteria. A proposed change would be to use the Translated Services column in a Manual NAT rule, which addresses the different requirement to translate the destination service port for one published server. Which action instead addresses the observed incident?

  1. Place the intended matching rule first in the NAT rule order
  2. Create a Manual NAT rule with both translated fields
  3. Account for separate matching automatic source and destination rules
  4. Use the Translated Services column in a Manual NAT rule

Explanation

Correct Answer

B:

Manual NAT allows simultaneous source and destination translation. This directly addresses the documented incident evidence.

Incorrect Answers

A:

Only the first matching Manual NAT rule is enforced; this does not resolve the observed condition.

C:

Automatic NAT can enforce matching source and destination rules, yet that applies to handle an automatic source and destination NAT match rather than the observed issue.

D:

Manual NAT can translate services as well as addresses, but the current evidence calls for a different R82 operation.

Question 640

A Security Gateway has active and backup external VPN interfaces. The primary next hop becomes unreachable during a maintenance test, but the gateway keeps trying that circuit. The cloud peer is otherwise healthy. The operator must distinguish this from a separate requirement to provide multi-link cloud IPsec interoperability on a supported fixed-address, non-ElasticXL R82 gateway. Which supported change follows from the actual evidence rather than that alternative hypothesis?

  1. Configure Link Selection probing and redundant paths
  2. Configure supported Enhanced Link Selection interfaces and redundancy for the cloud peer
  3. Configure the gateway Link Selection settings
  4. Configure VPN Load Sharing through Link Selection when supported

Explanation

Correct Answer

A:

Availability probes help choose working links. This directly addresses the documented incident evidence.

Incorrect Answers

B:

Enhanced Link Selection supports cloud IPsec redundancy without proprietary RDP, with DAIP and platform limits, but the current evidence calls for a different R82 operation.

C:

Link Selection controls VPN interface and address selection; this does not resolve the observed condition.

D:

VPN Link Selection can share VPN traffic across available links, yet that applies to define how VPN traffic is distributed across multiple usable links rather than the observed issue.

Check Point Certified Security Expert - R82 (CCSE) (156-315.82) Practice Tests