McAfee-Secured Website

Exam Code: 156-315.82

Exam Name: Check Point Certified Security Expert - R82 (CCSE)

Certification Provider: Checkpoint

Corresponding Certification: CCSE R82

Questions & Answers

100% Checkpoint 156-315.82 Guaranteed Success With Testking Training Materials

Get Real 156-315.82 Exam Questions & Expert Verified Answers as Experienced on the Real Exam!

Questions & Answers

100 Questions & Answers with Testing Engine

"Check Point Certified Security Expert - R82 (CCSE) Exam", also known as 156-315.82 exam, is a Checkpoint certification exam.

Pass your tests with the always up-to-date 156-315.82 Exam Engine. Your 156-315.82 training materials keep you at the head of the pack!

Satisfaction Guaranteed

Money Back Guarantee

Testking provides hassle-free money back guarantee with our products. That is because we have 100% trust in the abilities of our professional and experience product team, and our record is a proof of that.

99.6% PASS RATE
Was: $137.49
Now: $124.99

Checkpoint 156-315.82 Practice Test 40

Question 390

An R82 Security Gateway must move to a specifically approved major release, while its current Jumbo Hotfix is already adequate. The change must run remotely through supported Central Deployment. A preliminary suggestion is to review the package installation and gateway version result. The incident evidence instead points to a different control within the same R82 subsystem. What is the most relevant action?

  1. Review the package installation and gateway version result
  2. Use supported Central Deployment parallel target selection
  3. Use SmartConsole Central Deployment where supported
  4. Use Central Deployment Version Upgrade to Specific Major Version

Explanation

Correct Answer

D:

Central Deployment offers target-version selection. This directly addresses the documented incident evidence.

Incorrect Answers

A:

Actual installed version proves the deployment target state, but the current evidence calls for a different R82 operation.

B:

Central Deployment can process several supported targets, yet that applies to upgrade multiple gateway targets efficiently rather than the observed issue.

C:

Central Deployment is the documented gateway best practice; this does not resolve the observed condition.

Question 391

A replacement management appliance is blank, while the source R82 export is verified and ready. An engineer proposes copying the database directly onto an old unsupported installation. The controls that address the separate requirement to confirm a valid management license before import are already working as designed, and the change ticket must not disturb them. Which R82 action addresses the remaining symptom?

  1. Use Upgrade with Migration for new-server clean-install cutover
  2. Perform a supported clean installation of R82 on the target
  3. Verify license state on the destination with cplic print
  4. Back up the current management configuration first

Explanation

Correct Answer

B:

A clean R82 target is a documented migration destination. This directly addresses the documented incident evidence.

Incorrect Answers

A:

Migration exports management state and imports to a separate target, yet that applies to select an appropriate migration pathway between hosts rather than the observed issue.

C:

License validation is part of the documented import preparation, but the current evidence calls for a different R82 operation.

D:

The R82 migration procedure begins with source backups; this does not resolve the observed condition.

Question 392

A newly admitted R82 ElasticXL appliance boots with an empty local configuration and the initial site SMO has the approved image and cluster configuration. An engineer wants to configure each new member independently by hand. A proposed change would be to inspect /var/log/lightshot.log on the relevant member, which addresses the different requirement to investigate image-cloning progress problems. Which action instead addresses the observed incident?

  1. Allow the automatic image/configuration clone from SMO
  2. Inspect /var/log/lightshot.log on the relevant member
  3. Expect the SMO to accept and distribute traffic to members
  4. Use insights or show cluster info provision live

Explanation

Correct Answer

A:

ElasticXL copies the SMO image and settings to added members. This directly addresses the documented incident evidence.

Incorrect Answers

B:

The lightshot log documents SMO snapshot and image cloning, but the current evidence calls for a different R82 operation.

C:

The SMO handles distribution to other site members, yet that applies to verify the distribution architecture within one site rather than the observed issue.

D:

ElasticXL provides member onboarding and clone status commands; this does not resolve the observed condition.

Question 393

Following a virtual-switch maintenance change, SmartConsole reports the two R82 management peers as Not Communicating. The administrator can still log in locally to each server, but cannot reach the other peer across the management VLAN. The operator must distinguish this from a separate requirement to review whether the management HA partner is synchronized. Which supported change follows from the actual evidence rather than that alternative hypothesis?

  1. Check connectivity between management servers first
  2. Initiate a manual synchronization between management peers
  3. Open the Management High Availability status in SmartConsole
  4. Test Secure Internal Communication between the HA peers

Explanation

Correct Answer

A:

Peer reachability is a first troubleshooting check for lost communication. This directly addresses the documented incident evidence.

Incorrect Answers

B:

A manual sync is the documented response to Sync Error; this does not resolve the observed condition.

C:

Management HA status reports peer role and synchronization health, but the current evidence calls for a different R82 operation.

D:

SIC testing helps isolate authentication or trusted-channel issues, yet that applies to investigate failed management peer authentication rather than the observed issue.

Question 394

An R82 firewall policy change includes two new Manual NAT rules and an updated associated Access Control rule. SmartConsole still shows the session unpublished; the gateway continues enforcing the previous installed policy. An alternate diagnosis concerns the requirement to apply different port translation only to selected services, for which a colleague suggests match Original Services and set corresponding Translated Services. Based on the recorded symptoms, which corrective step should have priority?

  1. Match Original Services and set corresponding Translated Services
  2. Publish the session and install the relevant security policy
  3. Create an appropriate one-direction Manual NAT policy rule
  4. Open Security Policies > Access Control > NAT

Explanation

Correct Answer

B:

Published and installed policy activates gateway enforcement changes. This directly addresses the documented incident evidence.

Incorrect Answers

A:

Manual NAT can restrict rules by service and translated port, but the current evidence calls for a different R82 operation.

C:

Manual NAT supports direction-specific static translation; this does not resolve the observed condition.

D:

The Access Control NAT policy contains manual translation rules, yet that applies to locate Manual NAT configuration in SmartConsole rather than the observed issue.

Question 395

The R82 gateway is configured for a third-party IPsec peer using a pre-shared secret. Both ends agree on IKE version and algorithms, but logs show authentication failure after the partner rotated its shared key. The controls that address the separate requirement to troubleshoot a stable VPN phase-one but no protected data are already working as designed, and the change ticket must not disturb them. Which R82 action addresses the remaining symptom?

  1. Review IKE negotiation settings and authentication on both peers
  2. Verify phase-two traffic selectors and matching policy rules
  3. Configure matching pre-shared keys on both VPN peers
  4. Configure accepted peer certificates and trusted issuing authority

Explanation

Correct Answer

C:

Both sides need consistent configured IKE authentication secrets. This directly addresses the documented incident evidence.

Incorrect Answers

A:

IKE agreement and authentication are prerequisites for tunnel setup; this does not resolve the observed condition.

B:

Data associations still need matching selectors and permitted traffic, but the current evidence calls for a different R82 operation.

D:

Certificate authentication relies on valid identities and trust, yet that applies to authenticate a third-party VPN peer with certificates rather than the observed issue.

Question 396

During an R82 Compliance Blade assessment, the officer asks which regulatory requirement has failed and how the policy scores against that framework. SmartEvent attack counts are available but unrelated. A preliminary suggestion is to activate the Compliance Software Blade. The incident evidence instead points to a different control within the same R82 subsystem. What is the most relevant action?

  1. Generate a Compliance Blade report in the Reports view
  2. Configure Event Format field display mapping
  3. Activate the Compliance Software Blade
  4. Review Regulatory Compliance requirements and scores

Explanation

Correct Answer

D:

Compliance maps checks to selected regulatory requirements. This directly addresses the documented incident evidence.

Incorrect Answers

A:

Compliance reporting supports a PDF output, yet that applies to prepare a PDF summary of compliance findings rather than the observed issue.

B:

Event Format determines which event details are displayed; this does not resolve the observed condition.

C:

Compliance evaluates Check Point security best practices, but the current evidence calls for a different R82 operation.

Question 397

An audit change advisory names a specific CPUSE Jumbo Hotfix rather than the newest available package. The gateway is eligible, but selecting the GUI’s Recommended Major Version would exceed the authorized change. A proposed change would be to check Management Server connectivity to selected gateways, which addresses the different requirement to verify network reachability for remote package deployment. Which action instead addresses the observed incident?

  1. Check Management Server connectivity to selected gateways
  2. Use the Install Hotfix/Jumbo deployment action
  3. Choose Install a Specific Hotfix/Jumbo and enter the filename
  4. Search for the named Hotfix/Jumbo package in deployment UI

Explanation

Correct Answer

D:

The specific-package lookup matches the approved advisory. This directly addresses the documented incident evidence.

Incorrect Answers

A:

Remote deployment depends on control connectivity to targets, but the current evidence calls for a different R82 operation.

B:

Hotfix deployment targets fixes on the existing release; this does not resolve the observed condition.

C:

Specific package selection targets the intended hotfix, yet that applies to install a specific rather than latest hotfix package rather than the observed issue.

Question 398

A Security Management Server must be replaced with a new machine while retaining its policies, objects and database. The target will receive a clean supported R82 installation, rather than updating the source host in place. A proposed change would be to perform a supported clean installation of R82 on the target, which addresses the different requirement to prepare the target machine for a management migration. Which action instead addresses the observed incident?

  1. Connect the new management host on the intended network
  2. Use Upgrade with Migration for new-server clean-install cutover
  3. Perform a supported clean installation of R82 on the target
  4. Disconnect the retired source before activating its replacement

Explanation

Correct Answer

B:

Migration exports management state and imports to a separate target. This directly addresses the documented incident evidence.

Incorrect Answers

A:

The new server needs appropriate network connectivity to manage gateways, yet that applies to bring the replacement management server online after import rather than the observed issue.

C:

A clean R82 target is a documented migration destination, but the current evidence calls for a different R82 operation.

D:

Controlled cutover prevents conflicting management authorities; this does not resolve the observed condition.

Question 399

An R82 ElasticXL cluster has four physical appliances within one logical security gateway. A new engineer proposes creating four standalone SmartConsole gateway objects and installing unrelated policies to each. The controls that address the separate requirement to initialize a new ElasticXL installation are already working as designed, and the change ticket must not disturb them. Which R82 action addresses the remaining symptom?

  1. Run Gaia First Time Configuration Wizard on the first appliance only
  2. Add supported members through ElasticXL admission and cloning
  3. Create one Single Management Object for the entire cluster
  4. Use Gaia Portal Cluster Management Actions > Delete

Explanation

Correct Answer

C:

ElasticXL exposes one logical Security Gateway management object. This directly addresses the documented incident evidence.

Incorrect Answers

A:

The first appliance establishes the configuration cloned to members, but the current evidence calls for a different R82 operation.

B:

ElasticXL is designed to scale membership under one gateway object, yet that applies to scale out the cluster without changing the gateway identity rather than the observed issue.

D:

Cluster Management supports member removal; this does not resolve the observed condition.

Question 400

After a management-link outage, both R82 Management Servers show Active in the HA status pane. Each has accepted changes while isolated. The owner has chosen which database to retain and captured the other changes. The controls that address the separate requirement to make configuration changes while the management pair remains healthy are already working as designed, and the change ticket must not disturb them. Which R82 action addresses the remaining symptom?

  1. Use Management HA actions to set one server to Standby
  2. Use the Active Management Server for write operations
  3. Initiate changeover so a healthy standby becomes Active
  4. Leave the newly defined secondary Management Server in Standby

Explanation

Correct Answer

A:

One Active server is required for a consistent normal HA state. This directly addresses the documented incident evidence.

Incorrect Answers

B:

Only the Active server accepts normal management changes, but the current evidence calls for a different R82 operation.

C:

A controlled management changeover restores an Active management server, yet that applies to recover administration when the active management node goes offline rather than the observed issue.

D:

Secondary management servers start in Standby by default; this does not resolve the observed condition.

Check Point Certified Security Expert - R82 (CCSE) (156-315.82) Practice Tests