Question 550
You have attempted this task on a test RHEL10 instance: A new network connection profile was edited but the operator attempts an unsafe remote restart of all networking services. Which command output or observation best confirms its success?
Explanation
Correct Answer
The profile reflects changed settings and existing remote management remains recoverable. This check confirms the expected effect of: Use a supported `nmcli connection up lablan` or `nmcli device reapply <interface>` procedure after confirming console access and change scope. It distinguishes the intended result from the original failure mechanism: NetworkManager applies connection profile changes; restarting the entire stack is rarely necessary.
Incorrect Answers
`nmcli dev show` and `getent hosts server.lab` show the approved DNS servers and expected name resolution. That verifies a separate lab task: A host resolves internal names through an obsolete DNS server even though its IPv4 address is correct. It does not validate the implementation required here: Use a supported `nmcli connection up lablan` or `nmcli device reapply <interface>` procedure after confirming console access and change scope.
The listener remains available after a controlled reboot and `systemctl is-enabled httpd` reports enabled. That verifies a separate lab task: A web service must start after every reboot, but `ss -tln` shows its listener only after manual execution. It does not validate the implementation required here: Use a supported `nmcli connection up lablan` or `nmcli device reapply <interface>` procedure after confirming console access and change scope.
The port remains listed in permanent configuration and works after a controlled reboot. That verifies a separate lab task: An operator opens an authorized lab TCP port using only the runtime firewalld command, so access disappears after reboot. It does not validate the implementation required here: Use a supported `nmcli connection up lablan` or `nmcli device reapply <interface>` procedure after confirming console access and change scope.