Question 230
At Evercrest Rail Logistics, while validating an automation transaction, the data center fabric team observes: A routed port is configured with an IP address under an unexpected subinterface context. Which result would establish that the original defect has been corrected?
Explanation
Correct Answer
At Evercrest Rail Logistics, while validating an automation transaction, this result is the relevant closure evidence: The appropriate interface reports the expected address and directly connected route. It checks the effect of: Correct the interface hierarchy and apply the intended Layer 3 address to the approved subinterface. The underlying issue was: The IP addressing change was attached to the wrong interface or subinterface scope.
Incorrect Answers
At Evercrest Rail Logistics, while validating an automation transaction, this option proposes: A corrected link maintains stable operational status with no recurring error growth. The option describes a different failure mode: A high-speed interface shows rapidly increasing errors while routing sessions still intermittently recover. It would address The fault is in the physical link or transceiver rather than solely in routing policy, but here the case reports A routed port is configured with an IP address under an unexpected subinterface context. The current required evidence is: The appropriate interface reports the expected address and directly connected route.
At Evercrest Rail Logistics, while validating an automation transaction, this option proposes: A rehearsal restores the known-good state if the change acceptance test fails. That choice would be more relevant when this different symptom occurs: An engineer makes a risky multi-node edit without saving a known-good baseline. The present scenario instead points to: The IP addressing change was attached to the wrong interface or subinterface scope. The correct resolution has its own verification outcome: The appropriate interface reports the expected address and directly connected route.
At Evercrest Rail Logistics, while validating an automation transaction, this option proposes: The test prefix and its selected next hops appear only in the expected routing instance. This is a valid category of fabric maintenance for another scenario (An operator inspects an IPv4 route in a tenant instance but checks the default IPv4 table), not the targeted action for Evercrest Rail Logistics. The distinction is the actual cause: The IP addressing change was attached to the wrong interface or subinterface scope.