Question 240
A Fortinet SD-WAN/FortiSASE operations team encounters the following situation: A video production site shifts between two otherwise healthy overlay links during short traffic bursts, disrupting streams that require path consistency. Which sustained control would best prevent this same failure from recurring?
Explanation
Correct Answer
This guard addresses the recurring failure mode demonstrated by the case: Selection behavior reacts to transient conditions without honoring application continuity needs. It guards the same affected workflow, rather than merely checking that some other service works. A successful controlled outcome would be: Streams retain a stable healthy overlay during short bursts and change path when the sustained SLA truly fails.
Incorrect Answers
This control is relevant to another scenario in the stated requirement, specifically: A new spoke cannot negotiate its overlay because its encryption proposals do not overlap those approved on the datacenter peer. It would not prevent the present mechanism: Selection behavior reacts to transient conditions without honoring application continuity needs. Prevention must be linked to that actual failure mode rather than a generic adjacent control.
This control is relevant to another scenario in the stated requirement, specifically: A hub logs incoming branch ESP traffic but application replies are forwarded through a different unprotected link after a route change. It would not prevent the present mechanism: Selection behavior reacts to transient conditions without honoring application continuity needs. Prevention must be linked to that actual failure mode rather than a generic adjacent control.
This control is relevant to another scenario in the stated requirement, specifically: A regional IPsec tunnel stays reported as established after an ISP black hole because the environment has no effective peer-liveness detection. It would not prevent the present mechanism: Selection behavior reacts to transient conditions without honoring application continuity needs. Prevention must be linked to that actual failure mode rather than a generic adjacent control.