Question 470
Original unofficial HPE0-J83 storage practice case R183-CASE-118 — Factory brings up Fibre Channel uplinks. Observed evidence: Port shows link light but fabric login fails due to unsupported transceiver mode. After the scoped corrective action, which observation most directly demonstrates that this issue is resolved?
Explanation
Correct Answer
The acceptance result The expected WWPN completes fabric login at the supported speed directly tests recovery for this situation: Link-layer compatibility differs from visual link status. The prior signal was: Port shows link light but fabric login fails due to unsupported transceiver mode. The planned intervention was: Check HPE-supported SFP speed and switch interoperability for the chosen ports. This targeted evidence is more useful than merely reporting that an array is online.
Incorrect Answers
Incorrect for this case-specific acceptance test. That result would demonstrate progress against: Shared LUN use lacks clustered filesystem ownership, signaled by: Two hosts independently initialize their filesystem on the same block device. The current symptom is: Port shows link light but fabric login fails due to unsupported transceiver mode. Verify this incident by checking: The expected WWPN completes fabric login at the supported speed.
Incorrect for this case-specific acceptance test. That result would demonstrate progress against: Storage traffic segregation and allowed path controls were not implemented, signaled by: iSCSI data VLAN shares an uncontrolled broadcast network with management users. The current symptom is: Port shows link light but fabric login fails due to unsupported transceiver mode. Verify this incident by checking: The expected WWPN completes fabric login at the supported speed.
Incorrect for this case-specific acceptance test. That result would demonstrate progress against: Thin provisioning controls are missing from acceptance criteria, signaled by: Host receives a large thin LUN while the provisioning workflow omits physical capacity thresholds. The current symptom is: Port shows link light but fabric login fails due to unsupported transceiver mode. Verify this incident by checking: The expected WWPN completes fabric login at the supported speed.